OPTIMIZATION APPROACH FOR DESIGN OF SPUR GEAR BASED ON GENETIC ALGORITHM
Abstract -Â The problem of designing spur gear with minimum mass and smaller size without violating the constraints plays a major role in todayâ€™s industrial world, since the most commonly encountered mechanical power transmission require low weight. This paper presents an genetic approach to reduce the weight and thickness of the gear, also increases the power transmitting capacity and effectiveness using genetic algorithm (GA). It can be observed that the proposed optimal design with GA has the potential to yield considerably better solutions than the traditional heuristics. At the same time, the GA offer a better understanding of the trade-offs between various constraints.
Key words: Optimal design, genetic algorithm, Spur gear
2. Bentley P. An introduction to evolutionary design by computers. In: Evolutionary Design by Computers. San Francisco: Morgan Kaufmann; 1999.
3. Deb K, Jain S. Multi-speed gearbox design using multi-objective evolutionary algorithms. ASME J Mech Des 2003;125:609-19.
4. Deutsches Institut Für Normung EV. Din 3990, Tragfähigkeitsberechnung von
Stirnrädern Teil 3. Berlin: Deutsches Institut Für Normung EV; 1987.
5. Gologlu C, Zeyveli M. A genetic approach to automate preliminary design of gear drives. Comput Ind Eng 2009;57:1043-51.
6. Grote K, Antonsson EK. Springer Handbook of Mechanical Engineering. Heidelberg: Springer; 2009.
7. Holland JH. Adaptation in Natural and Artificial Systems. Ann Arbor:The University of Michigan Press; 1975.
8. Huang HZ, Tian ZG, Zuo M. Multiobjective optimization of three- stage spur gear reduction units using interactive physical programming. J Mech Sci Technol 2005;19:1080.
9. Li X, Symmons GR. Optimal design of involute profile helical gears. Mech Mach Theory 1996;31:717-28.
10. Lin Y, Shea K. A Method and Software Tool for Automated Gearbox Synthesis. San Diego, California, USA: Proceedings of the ASME International Design Engineering Technical Conferences and
Computers and Information in Engineering Conference; 2009. p. 1-11.
11. Madhusudan G, Vijayasimha CR. Approach to spur gear design. Comput Aided Des 1987;19:555-9.
12. Ray T, Saini P. Engineering design optimization using a swarm with an intelligent information sharing among individuals. Eng Optim 2001;33:735-48.
13. Renner G, Ekárt A. Genetic algorithms in computer aided design. Comput Aided Des 2003;35:709-26.
14. Savsani V, Rao RV, Vakharia DP. Optimal weight design of a gear train
using particle swarm optimization and simulated annealing algorithms. Mech Mach Theory 2010;45:531-41.
15. Thompson DF, Gupta S, Shukla A. Tradeoff analysis in minimum volume design of multi-stage spur gear reduction units. Mech Mach Theory 2000;35:609-27.
16. Tudose L, Buiga O, Stefanache C, Sobester A. Automated optimal design of a two-stage helical gear reducer. Struct Multidiscip Optim 2010;42:429-35.
17. Yokota T, Taguchi T, Gen M. A solution method for optimal weight design problem of the gear using genetic algorithms. Comput Ind Eng 1998;35:523-6.
This work is licensed under a Creative Commons Attribution 4.0 International License.